Developed specifically for high retention Heating Hot and Chilled Water Closed Loop Systems where the use of Molybdenum has become either banned from discharge or deemed as too costly. The product is applicable in systems with existing Iron Corrosion Deposits.
CL-3 will form its pacifying film with the existing Iron Corrosion By-Products. Other inhibitor formulas may tend to “push” the existing deposits throughout the system. Caution should be taken when CL-3 is applied to systems with concentrations of Dissolved Iron exceeding 10 ppm. The CL-3 should then be introduced to the system such that Silica residual slowly (over a 3 to 5 day period) rises into the desired range. High volume flow capacity and automated backwashing filtration must be used until the Dissolved Iron residual drops below 3 ppm.
This product is highly recommended in systems with continuous or consistent system water losses resulting in make-up over 10% of total system volume. CL-3 is effective in maintaining corrosion free waterside surfaces in these otherwise highly corrosive environments. CL-3 is a proprietary blend of high performance raw materials designed to control corrosion within Industry Standards. It is a mixture of organic and inorganic inhibitors. CL-3 is rated as Non-Hazardous and has been formulated without any heavy metals. This formula is “GREEN”. It can be used in systems where Heavy Metals and/or many other Discharge Regulations or Cost limitations prohibit the use of other Inhibitors. CL-3 has been blended with a unique ratio of raw materials. The specific ratio allows for a single Silica test to be used to control the product feed rate.